LAMKIN UTX GOLF GRIP GREY – STANDARD

The Lamkin UTX is a revolutionary multi-layer golf grip that takes all-weather performance and great-feeling playability to a new extreme. Fueled by Lamkins Tri-Layer technology, UTx grips provide exceptional traction and comfort in any playing conditions.

Lamkin UTX Golf Grip Features:

Made with Tri-Layer Technology, blending three unique materials
The perfect-feeling grip Softer ACE foundation for enhanced comfort and feel
Full-cord fabric weave wicks moisture and increases grip traction
Firmer outer layer of ACE material provides superior torsion control and vibration dampening
Outstanding all-weather performance, ideal in humid and wet conditions
Promotes the ideal light-pressure grip for longer and more consistent shots

+FREE GRIP TAPE INCLUDED WITH EACH GRIP
STEP-BY-STEP REGRIPPING INSTRUCTIONS
The following supplies are needed:
1.PRO-GRIP DOUBLE SIDED GRIP TAPE
2.STANLEY KNIFE / BLADE
3.NEW GOLF GRIP
4.SOLVENT WHITE SPIRITS
5.RUBBER GLOVES TO PROTECT HANDS
6. TOWEL / CLOTH
STEP 1 – Remove the old grip with a Stanley blade Be sure to cut away from
yourself at all times. Peel or scrape off the old grip and grip tape.
Using a cloth and Mineral Spirits Grip Solvent, clean off the residue.
*If removing a grip from a graphite shaft be careful to avoid damage to the shaft
STEP 2 – Wrap your PRO-GRIP double sided grip tape in a spiral formation from
the top of the shaft to the point where the bottom of the grip will be on the shaft.
Remove the tape backing and cover the end of the shaft with extra tape.
STEP 3 – Cover the vent hole in the butt end with your finger or golf tee, and pour
a generous portion of Solvent such as white spirits inside the new grip. Close the
open end of the grip with your hand and shake to cover the entire inside of the grip.
STEP 4 – Pour the excess Mineral Spirits Grip Solvent (through the vent hole)
over the entire length of the two-sided tape. Apply generously. Use a tray to
catch excess Mineral Spirits Grip Solvent for use on other clubs.
STEP 5 – Place the grip over the shaft butt and Push the grip entirely onto
the club. Be sure to push it all the way down and align the grip as desired.
This must be done while the grip tape is still wet.
STEP 6 – Allow grips to dry for several hours before playing.