GOLF PRIDE TOUR VELVET ALIGN GOLF GRIP – STANDARD

Bring more consistency to your game by fitting your clubs with Golf Pride Tour Velvet ALIGN Grips. ALIGN Technology, which improves clubface awareness, utilizes a red ridge that rises and extends down the back of the grip for consistent, easily repeatable hand alignment. A state-of-the-art rubber blend maximizes comfort and playability in all playing conditions. The scientifically-designed, non-slip surface pattern pulls moisture away from the surface for a secure grip.
Golf Pride Tour Velvet Align Grip – Features:
#1 Grip Model played on all Worldwide Tours
ALIGN Technology improves clubface awareness to bring more consistency to your game
Red ridge rises and extends down back of grip to create more consistent hand alignment
State-of-the-art rubber blend for maximum playability and comfort in all playing conditions
Scientifically-designed, non-slip surface pattern pulls moisture away from the surface
STEP-BY-STEP REGRIPPING INSTRUCTIONS
The following supplies are needed:
1.PRO-GRIP DOUBLE SIDED GRIP TAPE
2.STANLEY KNIFE / BLADE
3.NEW GOLF GRIP
4.SOLVENT WHITE SPIRITS
5.RUBBER GLOVES TO PROTECT HANDS
6. TOWEL / CLOTH
STEP 1 – Remove the old grip with a Stanley blade Be sure to cut away from
yourself at all times. Peel or scrape off the old grip and grip tape.
Using a cloth and Mineral Spirits Grip Solvent, clean off the residue.
*If removing a grip from a graphite shaft be careful to avoid damage to the shaft
STEP 2 – Wrap your PRO-GRIP double sided grip tape in a spiral formation from
the top of the shaft to the point where the bottom of the grip will be on the shaft.
Remove the tape backing and cover the end of the shaft with extra tape.
STEP 3 – Cover the vent hole in the butt end with your finger or golf tee, and pour
a generous portion of Solvent such as white spirits inside the new grip. Close the
open end of the grip with your hand and shake to cover the entire inside of the grip.
STEP 4 – Pour the excess Mineral Spirits Grip Solvent (through the vent hole)
over the entire length of the two-sided tape. Apply generously. Use a tray to
catch excess Mineral Spirits Grip Solvent for use on other clubs.
STEP 5 – Place the grip over the shaft butt and Push the grip entirely onto
the club. Be sure to push it all the way down and align the grip as desired.
This must be done while the grip tape is still wet.
STEP 6 – Allow grips to dry for several hours before playing.