BETTINARDI SUPER STROKE PUTTER GRIP – TOUR 2.0

Our new Tour Series putter grips build on the success of our most successful grip models. Now with Traxion Control and Spyne Technology, the Tour Series putter grips offer golfers even more reasons to choose the No. 1 Putter Grip In Golf.

Bettinardi Super Stroke Putter Grip – Features

Traxion Control: An advanced surface texture that improves feedback and tack. It places “X-shaped” treads in high sensory areas on the sides and bottom of the grip to enhance feel and comfort.
No Taper Technology: Our patented technology helps golfers minimize grip pressure with a unique parallel design. The uniform lower hand profile assists golfers in quieting their hands and adding consistency to their stroke.
Spyne Technology: A heavily embossed ridge along the underside of the grip that guides golfers to repeatable hand placement, making it easier to square the face at impact and start more putts online.
Tech-Port: Allows golfers to counter-balance their putter to their specific needs. Tech-Port accepts all SuperStroke accessories including the CounterCore weight system.
Authorised Bettinardi Retailer

+FREE GRIP TAPE INCLUDED WITH EACH GRIP

STEP-BY-STEP REGRIPPING INSTRUCTIONS

The following supplies are needed:

1.PRO-GRIP DOUBLE SIDED GRIP TAPE
2.STANLEY KNIFE / BLADE
3.NEW GOLF GRIP
4.SOLVENT WHITE SPIRITS
5.RUBBER GLOVES TO PROTECT HANDS
6. TOWEL / CLOTH

STEP 1 – Remove the old grip with a Stanley blade Be sure to cut away from
yourself at all times. Peel or scrape off the old grip and grip tape.
Using a cloth and Mineral Spirits Grip Solvent, clean off the residue.
*If removing a grip from a graphite shaft be careful to avoid damage to the shaft

STEP 2 – Wrap your PRO-GRIP double sided grip tape in a spiral formation from
the top of the shaft to the point where the bottom of the grip will be on the shaft.
Remove the tape backing and cover the end of the shaft with extra tape.

STEP 3 – Cover the vent hole in the butt end with your finger or golf tee, and pour
a generous portion of Solvent such as white spirits inside the new grip. Close the
open end of the grip with your hand and shake to cover the entire inside of the grip.

STEP 4 – Pour the excess Mineral Spirits Grip Solvent (through the vent hole)
over the entire length of the two-sided tape. Apply generously. Use a tray to
catch excess Mineral Spirits Grip Solvent for use on other clubs.

STEP 5 – Place the grip over the shaft butt and Push the grip entirely onto
the club. Be sure to push it all the way down and align the grip as desired.
This must be done while the grip tape is still wet.

STEP 6 – Allow grips to dry for several hours before playing.