EVNROLL GRAVITY GRIP GOLF PUTTER GRIP – WHITE

The Gravity Grip Golf Putter Grip has an ultra-light EVA foam body that only weighs 35 grams and is moulded in a deep V shape. A 70 gram 10 steel rod is installed in the bottom of the V running the entire length of the grip. By positioning the weight directly under and a half-inch away from the shaft, the hands can feel the position of the putter face. Tying the hands to the putter face promotes keeping the putters face angle square thru the entire hitting area. This virtually eliminates face rotation at impact. The foam body, the steel rod and the outer wrap gives the Gravity Grip a total weight of 120 grams. This heavier-than-usual grip weight allows for more weight in the putter head. The result is a greater overall weight for increased stability and accuracy, while maintaining an ideal swing weight for optimum feel and distance control.

Gravity Grip Golf Putter Grip – Features:

Designed to help golfers Feel Square at address
Ultra-light EVA foam body weighs only 35g and is moulded into a deep V shape for feel
70g, 10 steel rod installed in the bottom of the V and running the length of the grip for stability
Heavier-than-usual grip weight allows for more weight in the head, increasing stability and accuracy
Total Weight: 120g
Authorised Evnroll Retailer

+FREE GRIP TAPE INCLUDED WITH EACH GRIP

STEP-BY-STEP REGRIPPING INSTRUCTIONS

The following supplies are needed:

1.PRO-GRIP DOUBLE SIDED GRIP TAPE
2.STANLEY KNIFE / BLADE
3.NEW GOLF GRIP
4.SOLVENT WHITE SPIRITS
5.RUBBER GLOVES TO PROTECT HANDS
6. TOWEL / CLOTH

STEP 1 – Remove the old grip with a Stanley blade Be sure to cut away from
yourself at all times. Peel or scrape off the old grip and grip tape.
Using a cloth and Mineral Spirits Grip Solvent, clean off the residue.
*If removing a grip from a graphite shaft be careful to avoid damage to the shaft

STEP 2 – Wrap your PRO-GRIP double sided grip tape in a spiral formation from
the top of the shaft to the point where the bottom of the grip will be on the shaft.
Remove the tape backing and cover the end of the shaft with extra tape.

STEP 3 – Cover the vent hole in the butt end with your finger or golf tee, and pour
a generous portion of Solvent such as white spirits inside the new grip. Close the
open end of the grip with your hand and shake to cover the entire inside of the grip.

STEP 4 – Pour the excess Mineral Spirits Grip Solvent (through the vent hole)
over the entire length of the two-sided tape. Apply generously. Use a tray to
catch excess Mineral Spirits Grip Solvent for use on other clubs.

STEP 5 – Place the grip over the shaft butt and Push the grip entirely onto
the club. Be sure to push it all the way down and align the grip as desired.
This must be done while the grip tape is still wet.

STEP 6 – Allow grips to dry for several hours before playing.