PRO-GRIP WIDE DOUBLE SIDED GOLF GRIP TAPE ROLL

PRO-GRIP Double sided golf grip tape is a superior quality tape designed specifically for the re gripping of golf clubs. As used by PGA golf professionals PRO-GRIP Double sided golf grip tape is ultra thin so that you can not feel it through your golf grip. Re gripping golf clubs is relatively simple, an entire set can be done in about 30 minutes. It is also a great way to ensure that your grips are fitted to suit yourself. 

PRO-GRIP Double sided golf grip tape – Features: 

Premium ultra thin grip tape
Golf specific tape with less residue
Width 48mm x Length 30 Metres
Enough tape for 80 x golf clubs 

STEP-BY-STEP REGRIPPING INSTRUCTIONS 

The following supplies are needed: 

PRO-GRIP DOUBLE SIDED GRIP TAPE
STANLEY KNIFE / BLADE
NEW GOLF GRIP
SOLVENT WHITE SPIRITS
RUBBER GLOVES TO PROTECT HANDS
TOWEL / CLOTH

STEP 1 – Remove the old grip with a Stanley blade Be sure to cut away from
yourself at all times. Peel or scrape off the old grip and grip tape.
Using a cloth and Mineral Spirits Grip Solvent, clean off the residue.
*If removing a grip from a graphite shaft be careful to avoid damage to the shaft 

STEP 2 – Wrap your PRO-GRIP double sided grip tape in a spiral formation from
the top of the shaft to the point where the bottom of the grip will be on the shaft.
Remove the tape backing and cover the end of the shaft with extra tape. 

STEP 3 – Cover the vent hole in the butt end with your finger or golf tee,
and pour a generous portion of Solvent such as white spirits inside the new grip.
Close the open end of the grip with your hand and shake to cover the entire inside of the grip. 

STEP 4 – Pour the excess Mineral Spirits Grip Solvent (through the vent hole)
over the entire length of the two-sided tape. Apply generously. Use a tray to
catch excess Mineral Spirits Grip Solvent for use on other clubs. 

STEP 5 – Place the grip over the shaft butt and Push the grip entirely onto the club.
 Be sure to push it all the way down and align the grip as desired.
This must be done while the grip tape is still wet. 

STEP 6 – Allow grips to dry for several hours before playing.