GOLF PRIDE REVERSE TAPER PUTTER GRIP – FLAT

The New Golf Pride Reverse Taper Putter Grip offers new technology that stabilises both hands during the putting stroke for a squarer putter face at impact – regardless of the player’s gripping style. The new Reverse Taper design features a slim upper hand section and a gradually wider lower hand section to create the ‘Reverse Taper’, in addition to a soft feel and enhanced tacky texture with dimple pattern for added traction. Through player testing and the gathering of consumer insights, Golf Pride has discovered that a common cause of players struggling with the putting stroke is more often than not, an overactive lower hand. Reverse Taper technology helps a player to smooth out the overactive tendencies of the lower hand, ultimately allowing each hand to perform at its optimal level and enhancing performance on the greens.

Golf Pride Reverse Taper Putter Grip – Features:

The first of the Stroke Enhancement Collection
Reverse Taper design with a slim upper hand and wider lower hand
Technology that stabilizes both hands for a more square putter face at impact*
Soft feel with enhanced tacky texture
Dimple pattern throughout grip to support traction
Available in both Medium 58R & Large 58R
Authorised Golf Pride Retailer

+FREE GRIP TAPE INCLUDED WITH EACH GRIP

STEP-BY-STEP REGRIPPING INSTRUCTIONS

The following supplies are needed:

1.PRO-GRIP DOUBLE SIDED GRIP TAPE
2.STANLEY KNIFE / BLADE
3.NEW GOLF GRIP
4.SOLVENT WHITE SPIRITS
5.RUBBER GLOVES TO PROTECT HANDS
6. TOWEL / CLOTH

STEP 1 – Remove the old grip with a Stanley blade Be sure to cut away from
yourself at all times. Peel or scrape off the old grip and grip tape.
Using a cloth and Mineral Spirits Grip Solvent, clean off the residue.
*If removing a grip from a graphite shaft be careful to avoid damage to the shaft

STEP 2 – Wrap your PRO-GRIP double sided grip tape in a spiral formation from
the top of the shaft to the point where the bottom of the grip will be on the shaft.
Remove the tape backing and cover the end of the shaft with extra tape.

STEP 3 – Cover the vent hole in the butt end with your finger or golf tee, and pour
a generous portion of Solvent such as white spirits inside the new grip. Close the
open end of the grip with your hand and shake to cover the entire inside of the grip.

STEP 4 – Pour the excess Mineral Spirits Grip Solvent (through the vent hole)
over the entire length of the two-sided tape. Apply generously. Use a tray to
catch excess Mineral Spirits Grip Solvent for use on other clubs.

STEP 5 – Place the grip over the shaft butt and Push the grip entirely onto
the club. Be sure to push it all the way down and align the grip as desired.
This must be done while the grip tape is still wet.

STEP 6 – Allow grips to dry for several hours before playing.